Eagle Electronics 350 S/MAP manual Transom

Models: 350 S/MAP

1 180
Download 180 pages 35.19 Kb
Page 29
Image 29

Mark the center of each slot for the mounting screw pilot holes. You will drill one hole in the center of each slot.

Drill the holes using the #29 bit (for the #10 screws).

Transom

Transom

Position transducer mount on transom and mark mounting holes.

Side view (left) and seen from above (right).

5.Attaching transducer to transom. Remove the transducer from the bracket and re-assemble it with the cable passing through the bracket over the bolt as shown in the following figures.

Route cable over bolt and through bracket. Side view (left) and seen

from above (right).

Attach the transducer to the transom. Slide the transducer up or down until it's aligned properly with the bottom of the hull as shown in the preceding and following figures. Tighten the bracket's mount- ing screws, sealing them with the sealant/adhesive compound.

21

Page 29
Image 29
Eagle Electronics 350 S/MAP manual Transom