
Recommended Tools and supplies
Recommended tools for this job include: wire pliers or wire stripper and a
wire cutter. Required supplies for this job include: two gray (18 gauge) or blue (16 gauge) wire nuts and electrical tape. Supplies are not included.
Wiring Diagram "A"
Begin by stripping the wire ends of the device you're connecting to the Cuda
350.(You'll notice the Cuda 350 data cable comes
Strip the ends of the VHF radio's data wires. Connect them to the pre-
stripped wires of the Cuda 250 data cable (shown right).
Twist the exposed wires together as shown in the following figures. If you're using a Uniden or similar radio, connect the radio's NMEA Wire to the Cuda 350 data cable's yellow wire, and the radio's Ground/Shield wire to the Cuda 350 data cable's black shield wire. If you're using an- other radio brand or NMEA device, see Wiring Diagram B instructions on page 161.