Eagle Electronics 350 S/MAP manual 160

Black	Cut black, blue
Blue
	and white.
White

Yellow

Bare wire (transmit) (shield)

After removing the adapter segment, prepare to connect by removing

and taping off unneeded wires. Strip the end of the yellow wire.

Strip about 1/4-inch (6.35 mm) of insulation from the yellow wire, then follow the preceding wire nut and taping instructions to connect the wires from the radio or other device.

If you are using a true RS-232 radio or other device, connect its (+) Re- ceive wire to the Cuda 350 data cable's yellow wire and its ground or (– ) Receive wire to the Cuda 350 data cable's bare shield wire.

	Yellow (Transmit)
Com port to
	Shield (Ground)
Cuda 250

(+) Receive or Receive
	To another
(–) Receive or ground
	NMEA device

Com port wiring to transmit NMEA information to another standard NMEA-compatible device.

When the data cable is connected to your VHF radio, all you have to do is plug it into the sonar/GPS unit. Attach the data cable's plug to the accessory socket on the right side of the back of your unit's case.

160