Eagle Electronics 500C manual 23.4 72.9 173.9 137.9 Millimeter 56.9 Inch

23.4

72.9

[2.87]

[0.92]

173.9 [6.85]

137.9

[5.43] 157.9

[6.22]

Millimeter	56.9
	[2.24]
[Inch]

Front view (left) and side view (right) showing dimensions of the

IntelliMap 500C when mounted on gimbal bracket.

After drilling the hole, pass the antenna connector up through the hole from under the dash. Pass the power cable's bare-wire end down though the hole from the top.

If you wish, you can fill in the hole around the cables with a good marine caulking compound. (Some marine dealers stock cable hole covers to con- ceal the opening.) No matter what type of installation you prefer, be sure to leave enough slack in the cables to allow tilting or swiveling the In- telliMap 500C. If you choose to fill in the hole, be sure to position the ca- bles against the rear edge of the hole as you apply the fill material.

Before positioning the bracket, be sure to hold the cables against the rear edge of the hole. Then, slide the bracket over the hole and butt the rear of the bracket base firmly against the cables, thus pinning them in place against the side of the hole. Finally, fasten the bracket to the dash. Attach the unit to the gimbal bracket using the supplied gimbal knobs and washers.

In-Dash Installation

You can mount the IntelliMap 500C in the dash with an optional FM-5 In-Dash Adapter Kit. The kit includes mounting hardware, a template for cutting the hole and an instruction sheet, part 988-0147-43.

17