Section 2: Installation & Accessories
Preparations
You can install the unit in some other order if you prefer, but we rec- ommend this installation sequence:
Caution:
You should read over this entire installation section before drill- ing any holes in your vessel!
1.Determine the approximate location for the unit, so you can plan how and where to route the cables for the transducer, any sensor and power. This will help you make sure you have enough cable length for the de- sired configuration.
NOTE:
The GPS antenna is inside the unit, so you must mount the unit in a location with an unobstructed view of the sky.
2.Determine the approximate location for the transducer, any sensor and their cable routes.
3.Determine the location of your battery or other power connection, along with the power cable route.
4.Install the transducer and route the transducer cable to the sonar unit. Install the speed or temp sensor, if applicable, and route the cable to the unit.
5.Route the power cable from the unit's location to an appropriate power source and connect it there.
6.Connect the transducer/power cable (and any sensor cables) to the unit and mount the unit on the bracket.
Transducer Installation
These instructions will help you install your Skimmer transducer on a transom, on a trolling motor or inside a hull. These instructions cover both single- and
Your Skimmer transducer typically comes packaged with a
13