Eagle Electronics 502cDF manual Dot, Alignment letters Positions Transducer

Dot

Align plastic ratchets in bracket.

B. Two-piece bracket: Locate the four plastic ratchets in the trans- ducer's hardware package. Press two ratchets into the sides of the plastic bracket and two on either side of the transducer as shown in the follow- ing illustrations. Notice there are letters molded into each ratchet. Place the ratchets into the bracket with the letter "A" aligned with the align- ment mark molded into the bracket. Place the ratchets onto the trans- ducer with the letter "A" aligned with the 12 o'clock position on the transducer stem. These positions set the transducer's coarse angle ad- justment for a 14° transom. Most outboard and stern-drive transoms have a 14° angle.

Alignment letters

	Alignment
	positions
Transducer	Transducer
bracket
Insert and align ratchets.
Transducer bracket	Transducer

RatchetRatchet

Add ratchets to bracket and transducer.

18