AT& Commands | Eicon Networks DIVA T/A ISDN Modem instruction

		Alphabetical List of Supported AT Commands
	AT& Commands

	AT&Cn	Data Carrier Detect	36

	AT&Dn	Data Terminal Ready	37

	AT&F	Loading Factory Profile	45

	AT&Kn	Flow Control	37

	AT&Sn	Data Set Ready	37

	AT&V	View Current and Stored Profile	45

	AT&Wn	Save Current to Stored Profile	45

	AT&Yn	Designate Stored Profile n as the Powerup Profile	45

	AT&Zn=v	Store Telephone Number(s)	40

DIVA T/A ISDN Modem Reference Guide ◆ Page 21

Image 21

Eicon Networks DIVA T/A ISDN Modem manual AT& Commands

Contents

Diva T/A Isdn Modem Reference Guide Eight Edition July 206-193-08 Contents Diva T/A Isdn Modem Reference Guide What is ISDN? What is ISDN? Channel Isdn Communication Channels Channel Basic Rate Access Connecting to Isdn BRI and PRI What is Multilink PPP? What is BACP/BOD? What is DBA? What is Always On / Dynamic Isdn AO/DI? What is Data Compression? Locating AT Commands Locating AT Commands AT Command Groups Alphabetical List of Supported AT Commands Alphabetical List of Supported AT Commands AT! Commands Alphabetical List of Supported AT Commands AT% Commands AT& Commands AT* Commands AT Commands AT@ Commands Other AT Commands Registers AT$ Utility Commands Mini-monitor Commands General AT Commands General AT Commands Isdn Configuration Commands DefaultsValues for n Isdn Configuration Commands Default1 None defaultINS-Net64, NI-1, or 5ESS, µ law will be used default AT!D3=n AT!N2=n Default null string this is an optional valueNumber. Numbers are separated by a semicolon AT!N3=n For more details, refer to the Rvscom documentation AT!X56=nOn region 255 do not attempt 56k data call retry COM Port Configuration Commands Ring COM Port Configuration Commands Upon connection, the Diva T/A reports the DCE speed For example, Connect Call Control Commands ATA Call Control Commands ATH Configuration Commands Configuration Commands AT!V0=n Use the default settings Profile Commands Multilink PPP Commands Multilink PPP Commands Endpoint Discriminator Class/Address AT%M3=b3c665ac11Internet Protocol IP Always On / Dynamic Isdn AT Commands Always On / Dynamic Isdn AT Commands Will be opened after the delay specified by AT!X10 AT!X13=n when Bacp is disabled, seeDefault 1000 bytes AT!X14=n Default AT!X22=n Default values for each setting, and is defined as followsAT!X18 Defined as follows AT!X25=n Default CF PPP overConnection numbers affects the range ofAT!X21. SeeAT!X21 AT!X26=n Utility Commands Internal TA access command reserved for VU Utility CommandsStart or display the Result of a Lapd trace Start or Display the Result of a PPP trace Enter the monitor on the next reset Soft reset the unit and enter the monitorStart an AO/DI X.25 Trace AT? Register Commands Register Commands Analog Device Commands AT*Fn Analog Device Commands Disable. Recommended for modem/fax calls To be disabledEnable with default values default Enable using same terminal endpoint identifier as data port Mini-monitor Commands AT Command Result Codes AT Command Result Codes ConnectCarrier Connect Connect 75T/1200R Protocol Transparent ModeConnect 1200T/75R Protocol None BACP/BOD Index