Manuals
/
Eicon Networks
/
Computer Equipment
/
Network Card
Eicon Networks
DIVA T/A ISDN Modem
manual
Diva T/A Isdn Modem Reference Guide
Models:
DIVA T/A ISDN Modem
1
1
66
66
Download
66 pages
21.53 Kb
1
2
3
4
5
6
7
8
Defaults
Connecting to Isdn BRI and PRI
Isdn Configuration Commands
Parameter is reset to
Locating AT Commands
What is
Protocol Transparent Mode
Page 1
Image 1
DIVA T/A ISDN Modem
Reference Guide
Page 1
Page 2
Page 1
Image 1
Page 1
Page 2
Contents
Diva T/A Isdn Modem Reference Guide
Eight Edition July 206-193-08
Contents
Diva T/A Isdn Modem Reference Guide
What is ISDN?
What is ISDN?
Channel
Isdn Communication Channels
Channel
Basic Rate Access
Connecting to Isdn BRI and PRI
What is Multilink PPP?
What is BACP/BOD?
What is DBA?
What is Always On / Dynamic Isdn AO/DI?
What is Data Compression?
Locating AT Commands
Locating AT Commands
AT Command Groups
Alphabetical List of Supported AT Commands
Alphabetical List of Supported AT Commands
AT! Commands
Alphabetical List of Supported AT Commands
AT% Commands
AT& Commands
AT* Commands
AT Commands
AT@ Commands
Other AT Commands
Registers
AT$ Utility Commands
Mini-monitor Commands
General AT Commands
General AT Commands
Defaults
Isdn Configuration Commands
Values for n
Isdn Configuration Commands
Default1
None default
INS-Net64, NI-1, or 5ESS, µ law will be used default
AT!D3=n
AT!N2=n
Default null string this is an optional value
Number. Numbers are separated by a semicolon
AT!N3=n
AT!X56=n
For more details, refer to the Rvscom documentation
On region 255 do not attempt 56k data call retry
COM Port Configuration Commands
Ring
COM Port Configuration Commands
Upon connection, the Diva T/A reports the DCE speed
For example, Connect
Call Control Commands
ATA
Call Control Commands
ATH
Configuration Commands
Configuration Commands
AT!V0=n
Use the default settings
Profile Commands
Multilink PPP Commands
Multilink PPP Commands
AT%M3=b3c665ac11
Endpoint Discriminator Class/Address
Internet Protocol IP
Always On / Dynamic Isdn AT Commands
Always On / Dynamic Isdn AT Commands
Will be opened after the delay specified by AT!X10
AT!X13=n when Bacp is disabled, see
Default 1000 bytes
AT!X14=n
Default AT!X22=n
Default values for each setting, and is defined as follows
AT!X18
Defined as follows
AT!X25=n
Default CF PPP over
Connection numbers affects the range ofAT!X21. SeeAT!X21
AT!X26=n
Utility Commands
Internal TA access command reserved for VU
Utility Commands
Start or display the Result of a Lapd trace
Start or Display the Result of a PPP trace
Soft reset the unit and enter the monitor
Enter the monitor on the next reset
Start an AO/DI X.25 Trace
AT?
Register Commands
Register Commands
Analog Device Commands
AT*Fn
Analog Device Commands
Disable. Recommended for modem/fax calls
To be disabled
Enable with default values default
Enable using same terminal endpoint identifier as data port
Mini-monitor Commands
AT Command Result Codes
Connect
AT Command Result Codes
Carrier Connect
Connect 75T/1200R
Protocol Transparent Mode
Connect 1200T/75R
Protocol None
BACP/BOD
Index
Top
Page
Image
Contents