For example, Connect | Eicon Networks DIVA T/A ISDN Modem specs

COM Port Configuration Commands

AT\Vn

Connect Message Control. This command controls the format of connection messages.

n=0	Upon connection, the DIVA T/A reports the DTE speed only (default).
	For example, CONNECT 19200.
n=1	Upon connection, the DIVA T/A reports the DCE speed.
	For example, CONNECT 64000.

DIVA T/A ISDN Modem Reference Guide ◆ Page 38

Image 38

Eicon Networks DIVA T/A ISDN Modem manual For example, Connect, Upon connection, the Diva T/A reports the DCE speed

Contents

Diva T/A Isdn Modem Reference Guide Eight Edition July 206-193-08 Contents What is ISDN? Diva T/A Isdn Modem Reference Guide What is ISDN? Isdn Communication Channels Channel Channel Connecting to Isdn BRI and PRI Basic Rate Access What is Multilink PPP? What is BACP/BOD? What is DBA? What is Always On / Dynamic Isdn AO/DI? What is Data Compression? Locating AT Commands Locating AT Commands AT Command Groups Alphabetical List of Supported AT Commands AT! Commands Alphabetical List of Supported AT Commands Alphabetical List of Supported AT Commands AT% Commands AT& Commands AT* Commands AT Commands AT@ Commands Other AT Commands Registers AT$ Utility Commands Mini-monitor Commands General AT Commands General AT Commands Values for n Isdn Configuration CommandsDefaults Isdn Configuration Commands INS-Net64, NI-1, or 5ESS, µ law will be used default None defaultDefault1 AT!D3=n Number. Numbers are separated by a semicolon Default null string this is an optional valueAT!N2=n AT!N3=n On region 255 do not attempt 56k data call retry For more details, refer to the Rvscom documentationAT!X56=n COM Port Configuration Commands COM Port Configuration Commands Ring For example, Connect Upon connection, the Diva T/A reports the DCE speed Call Control Commands Call Control Commands ATA ATH Configuration Commands Configuration Commands Use the default settings AT!V0=n Profile Commands Multilink PPP Commands Multilink PPP Commands Internet Protocol IP Endpoint Discriminator Class/AddressAT%M3=b3c665ac11 Always On / Dynamic Isdn AT Commands Always On / Dynamic Isdn AT Commands Default 1000 bytes AT!X13=n when Bacp is disabled, seeWill be opened after the delay specified by AT!X10 AT!X14=n AT!X18 Default values for each setting, and is defined as followsDefault AT!X22=n Defined as follows Connection numbers affects the range ofAT!X21. SeeAT!X21 Default CF PPP overAT!X25=n AT!X26=n Utility Commands Start or display the Result of a Lapd trace Utility CommandsInternal TA access command reserved for VU Start or Display the Result of a PPP trace Start an AO/DI X.25 Trace Enter the monitor on the next resetSoft reset the unit and enter the monitor Register Commands AT? Register Commands Analog Device Commands Analog Device Commands AT*Fn Enable with default values default To be disabledDisable. Recommended for modem/fax calls Enable using same terminal endpoint identifier as data port Mini-monitor Commands AT Command Result Codes Carrier Connect AT Command Result CodesConnect Connect 1200T/75R Protocol Transparent ModeConnect 75T/1200R Protocol None Index BACP/BOD