Locating AT Commands | Eicon Networks DIVA T/A ISDN Modem manual

Locating AT Commands

•The next command will only be accepted by the DIVA T/A once the previous command has been fully executed.

DIVA T/A ISDN Modem Reference Guide ◆ Page 15

Image 15

Eicon Networks DIVA T/A ISDN Modem manual Locating AT Commands

Contents

Diva T/A Isdn Modem Reference Guide Eight Edition July 206-193-08 Contents Diva T/A Isdn Modem Reference Guide What is ISDN? What is ISDN? Channel Isdn Communication Channels Channel Basic Rate Access Connecting to Isdn BRI and PRI What is Multilink PPP? What is BACP/BOD? What is DBA? What is Always On / Dynamic Isdn AO/DI? What is Data Compression? Locating AT Commands Locating AT Commands AT Command Groups Alphabetical List of Supported AT Commands Alphabetical List of Supported AT Commands AT! Commands Alphabetical List of Supported AT Commands AT% Commands AT& Commands AT* Commands AT Commands AT@ Commands Other AT Commands Registers AT$ Utility Commands Mini-monitor Commands General AT Commands General AT Commands Isdn Configuration Commands DefaultsValues for n Isdn Configuration Commands AT!D3=n None defaultDefault1 INS-Net64, NI-1, or 5ESS, µ law will be used default AT!N3=n Default null string this is an optional valueAT!N2=n Number. Numbers are separated by a semicolon For more details, refer to the Rvscom documentation AT!X56=nOn region 255 do not attempt 56k data call retry COM Port Configuration Commands Ring COM Port Configuration Commands Upon connection, the Diva T/A reports the DCE speed For example, Connect Call Control Commands ATA Call Control Commands ATH Configuration Commands Configuration Commands AT!V0=n Use the default settings Profile Commands Multilink PPP Commands Multilink PPP Commands Endpoint Discriminator Class/Address AT%M3=b3c665ac11Internet Protocol IP Always On / Dynamic Isdn AT Commands Always On / Dynamic Isdn AT Commands AT!X14=n AT!X13=n when Bacp is disabled, seeWill be opened after the delay specified by AT!X10 Default 1000 bytes Defined as follows Default values for each setting, and is defined as followsDefault AT!X22=n AT!X18 AT!X26=n Default CF PPP overAT!X25=n Connection numbers affects the range ofAT!X21. SeeAT!X21 Utility Commands Start or Display the Result of a PPP trace Utility CommandsInternal TA access command reserved for VU Start or display the Result of a Lapd trace Enter the monitor on the next reset Soft reset the unit and enter the monitorStart an AO/DI X.25 Trace AT? Register Commands Register Commands Analog Device Commands AT*Fn Analog Device Commands Enable using same terminal endpoint identifier as data port To be disabledDisable. Recommended for modem/fax calls Enable with default values default Mini-monitor Commands AT Command Result Codes AT Command Result Codes ConnectCarrier Connect Protocol None Protocol Transparent ModeConnect 75T/1200R Connect 1200T/75R BACP/BOD Index