![](/images/new-backgrounds/1194042/19404291x1.webp)
Multilink PPP Commands
The following table describes the MLPPP configuration commands.
AT%M1=n | Local Endpoint Discriminator Class. The value for ‘n’ specifies the Local Endpoint | |
| Discriminator Class. If you specify n=1 (class 1), the Local Endpoint Discriminator | |
| Address (specified with AT%M3=n) must be an even number. For a list of classes, see | |
| “Endpoint Discriminator Class/Address” on page 48. | |
|
| |
AT%M2=n | Remote Endpoint Discriminator Class. The value for ‘n’ specifies the Remote | |
| Endpoint Discriminator Class. For a list of classes, see “Endpoint Discriminator | |
| Class/Address” on page 48. | |
|
| |
AT%M3=n | Local Endpoint Discriminator Address. The value for ‘n’ specifies the Local | |
| Endpoint Discriminator Address. For a description of permitted addresses, see | |
| “Endpoint Discriminator Class/Address” on page 48. | |
|
| |
AT%M4=n | Remote Endpoint Discriminator Address. The value for ‘n’ specifies the Remote | |
| Endpoint Discriminator Address. For a description of permitted addresses, see | |
| “Endpoint Discriminator Class/Address” on page 48. | |
|
| |
AT%P5=n | Bandwidth Allocation Control Protocol (BACP) / Bandwidth on Demand (BOD). | |
| This command specifies whether BACP/BOD is enabled or disabled. When enabled, | |
| the DIVA T/A will drop to one B channel (reducing costs) when throughput drops | |
| below 64K. The DIVA T/A first attempts to negotiate BACP; if this is unsuccessful, the | |
| DIVA T/A falls back to BOD. | |
| n=0 | Disable (default). |
| n=1 | Enable. |
| Note: You can use this parameter only if the DIVA T/A has been configured for MLPPP. | |
|
| |
AT%P6=n | Set Initial Billing Interval Timer. Sets the timer (in seconds) to match the amount of | |
| time your ISDN provider allocates as the first time interval. | |
| Note: If the value is set to 0, the timer is not used. Setting this value to 0, also | |
| effectively sets AT%P7 to 0. | |
| Range: 0 to 65535. | |
| Default: 60 seconds. | |
|
| |
AT%P7=n | Set Billing Interval Timer. Sets the timer (in seconds) to match the amount of time | |
| your ISDN provider designates as the minimum chargeable unit for all subsequent | |
| billing. | |
| Note: If the value is set to 0, the timer is not used. | |
| Range: 0 to 65535. | |
| Default: 60 seconds. | |
|
|
|