General AT Commands | Eicon Networks DIVA T/A ISDN Modem manual

General AT Commands

A/

+++

Re-execute Previous Command. Re-executes all the commands in the command buffer. This command is mainly used to place another call (using the ATD dial command) that failed to connect due to a busy line, no answer, or a wrong number. This command is not preceded by AT nor followed by Enter.

Escape Sequence. The escape sequence is used to return to the command state from data state. To issue the escape sequence, wait a moment, enter the escape character three consecutive times (+++), then wait another moment. Its value is stored in S-Register 2. The default value of the escape character as stored in S-Register 2 is ‘+’.

DIVA T/A ISDN Modem Reference Guide ◆ Page 30

Image 30

Eicon Networks DIVA T/A ISDN Modem manual General AT Commands

Contents

Diva T/A Isdn Modem Reference Guide Eight Edition July 206-193-08 Contents What is ISDN? Diva T/A Isdn Modem Reference Guide What is ISDN? Isdn Communication Channels Channel Channel Connecting to Isdn BRI and PRI Basic Rate Access What is Multilink PPP? What is BACP/BOD? What is DBA? What is Always On / Dynamic Isdn AO/DI? What is Data Compression? Locating AT Commands Locating AT Commands AT Command Groups Alphabetical List of Supported AT Commands AT! Commands Alphabetical List of Supported AT Commands Alphabetical List of Supported AT Commands AT% Commands AT& Commands AT* Commands AT Commands AT@ Commands Other AT Commands Registers AT$ Utility Commands Mini-monitor Commands General AT Commands General AT Commands Isdn Configuration Commands DefaultsValues for n Isdn Configuration Commands INS-Net64, NI-1, or 5ESS, µ law will be used default None defaultDefault1 AT!D3=n Number. Numbers are separated by a semicolon Default null string this is an optional valueAT!N2=n AT!N3=n For more details, refer to the Rvscom documentation AT!X56=nOn region 255 do not attempt 56k data call retry COM Port Configuration Commands COM Port Configuration Commands Ring For example, Connect Upon connection, the Diva T/A reports the DCE speed Call Control Commands Call Control Commands ATA ATH Configuration Commands Configuration Commands Use the default settings AT!V0=n Profile Commands Multilink PPP Commands Multilink PPP Commands Endpoint Discriminator Class/Address AT%M3=b3c665ac11Internet Protocol IP Always On / Dynamic Isdn AT Commands Always On / Dynamic Isdn AT Commands Default 1000 bytes AT!X13=n when Bacp is disabled, seeWill be opened after the delay specified by AT!X10 AT!X14=n AT!X18 Default values for each setting, and is defined as followsDefault AT!X22=n Defined as follows Connection numbers affects the range ofAT!X21. SeeAT!X21 Default CF PPP overAT!X25=n AT!X26=n Utility Commands Start or display the Result of a Lapd trace Utility CommandsInternal TA access command reserved for VU Start or Display the Result of a PPP trace Enter the monitor on the next reset Soft reset the unit and enter the monitorStart an AO/DI X.25 Trace Register Commands AT? Register Commands Analog Device Commands Analog Device Commands AT*Fn Enable with default values default To be disabledDisable. Recommended for modem/fax calls Enable using same terminal endpoint identifier as data port Mini-monitor Commands AT Command Result Codes AT Command Result Codes ConnectCarrier Connect Connect 1200T/75R Protocol Transparent ModeConnect 75T/1200R Protocol None Index BACP/BOD