Eicon Networks DIVA T/A ISDN Modem manual COM Port Configuration Commands

COM Port Configuration Commands

The following AT commands pertain to the COM port configuration.

AT&Cn	Data Carrier Detect. This command controls the Data Carrier Detect (DCD) output.
	n=0	DCD always enabled.
	n=1	DCD tracks connection (default).
ATEn	Local Echo. The E command enables or disables command echo on your computer. If
	you do not see commands entered on your screen, enable command echo. If you see
	double characters, disable command echo.
	n=0	Disables local echo.
	n=1	Enables local echo (default).
ATQn	Quiet Result Codes. This command enables or disables the sending of result codes to
	the DTE.
	n=0	Enables result codes to the DTE (default).
	n=1	Disables result codes to the DTE.
ATVn	Result Code Format. You can set your DIVA T/A to display messages as digits or words.
	Word responses are preferable since they are more meaningful.
	n=0	Result codes are sent to the DIVA T/A as numbers (short form).
	n=1	Result codes are sent to the DIVA T/A as full words (long form/verbose) (default).
ATWn	Connect Message Control. This command controls the format of connection
	messages.
	n=0	Upon connection, the DIVA T/A reports the DTE speed only; for example,
		CONNECT 19200 (default).
	n=1	Upon connection, the DIVA T/A reports the DCE speed, the protocol, and the DTE
		speed.
	n=2	Upon connection, the DIVA T/A reports the DCE speed; for example, CONNECT
		64000.

DIVA T/A ISDN Modem Reference Guide ◆ Page 36