Eicon Networks DIVA T/A ISDN Modem Mini-monitor Commands

Alphabetical List of Supported ATCommands

DIVA T/A ISDN Modem Reference Guide ◆ Page 28

Mini-monitor Commands

These command are only available when you are in Mini-monitor mode; they are not

available when you are in command mode. The commands AT$Y or AT$Z will enter the

Mini-monitor; see page2 7 for more information. These commands are all case sensitive.

at@dump Dump Memory 62

at@d1 DRAM test 62

at@d2 Flash test 62

at@d3 ISDN internal loop back test 62

at@d4 ISDN external loop back test 62

at>F Restore Profiles to Original Settings 62

at@load Simulate a fault 62

at@load Load New Firmware 62

at@md arg Display memory 62

at@msg Display Cause for Entering Monitor 62

at@quit Exit the Mini-monitor mode. 62

Contents

Main Eight Edition (July 1999) 206-193-08 Content s What is ISDN? Page ISDN Communication Channels Page Connecting to ISDN - BRI and PRI What is Multilink PPP? What is BACP/BOD? What is DBA? What is Always On / Dynamic ISDN (AO/DI)? What is Data Compression? Locating AT Commands Page AT Command Groups Alphabetical List of Supported AT Commands AT! Commands Page AT% Co mm an d s AT& Co mm an ds AT* Co mm an d s AT> Commands Page Other AT Commands S-Registers AT$ (Utility) Commands Mini-monitor Commands General AT Commands The following table describes the general AT commands available to the DIVAT/A. Page ISDN Configuration Commands The following tabl e describes the ISDN Configura tion Commands. Page Page Page Page COM Port Configuration Commands The following AT comma nds pertai n to the COM por t configuratio n. Page Page Call Control Commands The following tab le describes th e Call Control Comm ands. Page Page V.120 Configuration Commands The following AT comm ands per tain to V.120 conf iguration o n your DIVAT /A. Page V.110 Configuration Commands Profile Commands The following table describes the profile commands: Multilink PPP Commands The following tabl e describes the MLPPP configu ration command s. Page Endpoint Discriminator Cla ss/Address The following tabl e describes the Always On / Dynamic ISDN AT Commands The following table describes the Always On/ D ynamic ISDN AT commands. Page Page Page Page Utility Commands The following table describes the Utility Commands. Page Page S-Register Commands The following five commands apply to S-Registers, which are described further below. S Register Parameters Page Analog Device Commands Page Page Mini-monitor Commands AT Command Result Codes Page Page Index A B C D