Other AT Commands | Eicon Networks DIVA T/A ISDN Modem manual

		Alphabetical List of Supported AT Commands
	Other AT Commands

	AT?	View Last Accessed S Switch	57

	AT=n	Last accessed S-Register to Value n	57

	ATA	Answer Calls	40

	A/	Re-execute Previous Command	30

	ATDn	Dial a Number	41

	ATEn	Local Echo	36

	ATH	Hang up a Call	41

	ATIn	View Product Information	29

	ATO	Return Online	29

	ATQn	Quiet Result Codes	36

	ATSn	Establishes S-Registers n as the selected register	57

	ATSn=v	S-Register n to Value v	57

	ATSn?	Value of S-Register n	57

	ATVn	Result Code Format	36

	ATWn	Connect Message Control	36

	ATXn	Extended Results Code	37

	ATZn	Restart the DIVA T/A	45

DIVA T/A ISDN Modem Reference Guide ◆ Page 25

Image 25

Eicon Networks DIVA T/A ISDN Modem manual Other AT Commands

Contents

Diva T/A Isdn Modem Reference Guide Eight Edition July 206-193-08 Contents Diva T/A Isdn Modem Reference Guide What is ISDN? What is ISDN? Channel Isdn Communication Channels Channel Basic Rate Access Connecting to Isdn BRI and PRI What is Multilink PPP? What is BACP/BOD? What is DBA? What is Always On / Dynamic Isdn AO/DI? What is Data Compression? Locating AT Commands Locating AT Commands AT Command Groups Alphabetical List of Supported AT Commands Alphabetical List of Supported AT Commands AT! Commands Alphabetical List of Supported AT Commands AT% Commands AT& Commands AT* Commands AT Commands AT@ Commands Other AT Commands Registers AT$ Utility Commands Mini-monitor Commands General AT Commands General AT Commands Defaults Isdn Configuration CommandsValues for n Isdn Configuration Commands Default1 None defaultINS-Net64, NI-1, or 5ESS, µ law will be used default AT!D3=n AT!N2=n Default null string this is an optional valueNumber. Numbers are separated by a semicolon AT!N3=n AT!X56=n For more details, refer to the Rvscom documentationOn region 255 do not attempt 56k data call retry COM Port Configuration Commands Ring COM Port Configuration Commands Upon connection, the Diva T/A reports the DCE speed For example, Connect Call Control Commands ATA Call Control Commands ATH Configuration Commands Configuration Commands AT!V0=n Use the default settings Profile Commands Multilink PPP Commands Multilink PPP Commands AT%M3=b3c665ac11 Endpoint Discriminator Class/AddressInternet Protocol IP Always On / Dynamic Isdn AT Commands Always On / Dynamic Isdn AT Commands Will be opened after the delay specified by AT!X10 AT!X13=n when Bacp is disabled, seeDefault 1000 bytes AT!X14=n Default AT!X22=n Default values for each setting, and is defined as followsAT!X18 Defined as follows AT!X25=n Default CF PPP overConnection numbers affects the range ofAT!X21. SeeAT!X21 AT!X26=n Utility Commands Internal TA access command reserved for VU Utility CommandsStart or display the Result of a Lapd trace Start or Display the Result of a PPP trace Soft reset the unit and enter the monitor Enter the monitor on the next resetStart an AO/DI X.25 Trace AT? Register Commands Register Commands Analog Device Commands AT*Fn Analog Device Commands Disable. Recommended for modem/fax calls To be disabledEnable with default values default Enable using same terminal endpoint identifier as data port Mini-monitor Commands AT Command Result Codes Connect AT Command Result CodesCarrier Connect Connect 75T/1200R Protocol Transparent ModeConnect 1200T/75R Protocol None BACP/BOD Index