Eicon Networks DIVA T/A ISDN Modem manual Multilink PPP Commands

Multilink PPP Commands

AT%P8=n	Dynamic Bandwidth Allocation (only available on models equipped with analog
	device ports). Specifies whether Dynamic Bandwidth Allocation (also known as Call
	Bumping) is enabled or disabled. When enabled, the DIVA T/A will automatically
	assign one of the two B channels (both used for data) to an incoming or outgoing
	analog device call (voice). When the call is completed, the DIVA T/A automatically
	reassigns the second B-channel to the data connection.
	n=0	Disable.
	n=1	Enable (default).
	Note: When BACP/BOD is enabled, the 2nd B channel is assigned as a data
	connection only if throughput is above 64KPS. Note also that you can use this
	parameter only if the DIVA T/A has been configured for MLPPP.
AT%P9=n	Second B-channel Connection Retries. Specifies the number of times the DIVA T/A
	tries to connect to the second B-channel when BOD is disabled.
	Range: 0-255. Note that when the ISDN Switch Type is set to Singapore (AT!C1=6), the
	range is 0-10.
	Default: 3.
AT%P10=n	Enable/Disable PPP Echo-Request. Specifies whether PPP Echo-Request is enabled
	or disabled. Certain services, such as IBM Global Services, require that PPP
	Echo-Request be disabled.
	n=1	Enable (default).
	n=0	Disable
AT!X13=n	Second B-channel Retry Delay (with BACP disabled). Specifies the number of
	seconds the DIVA T/A waits before it re-attempts to connect to the second B-channel.
	Range: 0-65535.
	Default: 5 seconds. Note that if the ISDN Switch Type is set to Singapore (AT!C1=6)
	then the default is 60 seconds.
	Note: The description above applies only if BACP is disabled; for a description of
	AT!X13=n when BACP is enabled, see page 51.

DIVA T/A ISDN Modem Reference Guide ◆ Page 47