Using the Adjustment Feet
The height of the projector can be adjusted using the adjustment feet at the front and rear of the projector when the screen is located higher than the projector, the screen is inclined or when the installation site is slightly inclined. Install the projector so that it is as perpen- dicular to the screen as possible.
Side View |
| Top View |
Lens 
center
1 Lift the projector to adjust its height while pressing the HEIGHT ADJUST button.
•The projector is adjustable up to approxi- mately 12 degrees (6 steps).
•When lowering the projector, it may be difficult to move the front adjustment foot because the installation surface is diffi- cult to slide. In this case, pull the pro- jector back slightly and adjust its height.
2 Remove your hands from the HEIGHT ADJUST button of the projector after its height has been finely adjusted.
3 Finely adjust the height and in- clination by turning the rear ad- justment feet.
Note
•When adjusting the projected image position, trapezoidal distortion occurs. In this case, see “Keystone Correction” on page 32.
Info
•Do not press the HEIGHT ADJUST button when the front adjustment foot comes out without firmly holding the projector.
•Do not hold the lens when lifting or lower- ing the projector.
•When lowering the projector, be careful not to get your fingers caught in the area be- tween the adjustment foot and the projector.
Front 
adjustment foot
HEIGHT ADJUST button
Rear adjustment feet
31
