Regarding the Lamp

4 Remove the lamp unit.

Loosen the two securing screws from the lamp unit. Hold the lamp unit by the handle and pull it in the direction of the arrow. At this time, keep the lamp unit horizontal and do not tilt it.

5 Insert the new lamp unit.

Press the lamp unit firmly into the lamp unit compartment. Fasten the securing screws.

6 Replace the lamp unit cover.

Align the lamp unit cover and slide it to close. Then tighten the user service screw to secure the lamp unit cover.

Info

If the lamp unit and lamp unit cover are not correctly installed, the power will not turn on, even if the power cord is connected to the projector.

Resetting the Lamp Timer

Reset the lamp timer after replacing the lamp.

Info

Make sure to reset the lamp timer only when replacing the lamp. If you reset the lamp timer and continue to use the same lamp, this may cause the lamp to become damaged or explode.

1 Connect the power cord.

Plug the power cord into the AC socket of the projector.

2 Reset the lamp timer.

Press , , , \, and on the projector in order, and then press on the projector.

“LAMP 0000H” is displayed on the lower left of the screen, indicating that the lamp timer is reset.

Handle

Securing screws

User service screw (for lamp unit cover)

AC socket

STANDBY-ON button

ENTER button

\/buttons

UNDO button

INPUT button

58

Page 61
Image 61
Eiki EIP-1500T owner manual Resetting the Lamp Timer