Removing and Installing the Lamp Unit
Warning!
•During projector operation, the lamp unit is very hot. Do not remove the lamp unit from the projector right after use. The lamp and parts around the lamp will be very hot and may cause burn or injury.
Info
•Make sure that you remove the lamp unit by the handle. Do not touch the glass sur- face of the lamp unit or the inside of the projector.
•To avoid injury to yourself and damage to the lamp, be sure to carefully follow the steps below.
•Do not loosen other screws except for the lamp unit cover and lamp unit.
Optional | Lamp unit |
accessory |
STANDBY-ON
1 Press 
on the projector or 
on the remote control to put the projector into standby mode.
•Wait until the cooling fan stops.
2 Disconnect the power cord.
•Unplug the power cord from the AC socket.
•Leave the lamp until it has fully cooled down (about 1 hour).
3 Remove the lamp unit cover.
AC socket
•Turn the projector over. Loosen the user service screw (1) that secures the lamp unit cover. Hold the tab and slide to- wards the direction of the arrow to re- move the lamp unit cover (2).
1
Tab
2
User service screw (for lamp unit cover)
Tab
57
