Running the Navisphere Storage System Initialization Utility
You ca n star t the storage system initialization u tility from the server
on which it is installedor from the server support CD. The storage
system initialization utility has two methods for executing commands
— a command line interfacethat can b e scripted,or a text-based u tility
that cannot be scripted.Beforecontinuingmakesurethatthestorage
system is powered up completely.
Note: Before using the Navisphere StorageSystem Initialization Utility, make
surethat you know the static IP addresses for the storage system SPs (for
example,http://123.45.6.7 and 123.45.6.8), the subnet mask, and thedefault
gatewayaddress. For storage system initialization, connect the server from
whichyou are running the utility and the storage system tothe same network
subnet,Once you have assigned an IP address to the storage system, the server
and storage system can be on different subnets.
Starting and using the storage system initialization utility on a Solaris server
Thissection describes the supported methods for starting and using the
storage system initialization utility.
Starting the initialization utility from a server
Tostart the text-based or command line utility from a server , enter:
/opt/Navisphere/bin/naviinittooland for the com mand line utility,
include any of the command lineswitches in Using the command line
initialization utility, page 15.
Starting the initialization utility from the CD
Tostart the text-based or command line utility from the CD, do the
following:
1. At the Solaris server,log in as superuser (root).
2. In the server’s drive, insert the server support CD, which shipped
with the storage system or the upgrade kit (forAX-series systems
upgrading to Navisphere Manager).
3. Navigate to the Solaris directory:
12 EMC CLARiiON Server Support Products for Solaris Server Installation Guide