Installing and removing the Admsnap Utility
EMC stronglyrecommends that you install admsnap on all servers
connected to a storage system that has the SnapViewdriver installed.
Important: If you are upgrading your storage system to FLARE OE
version 02.19.xxx.5.yyy or later,you must upgrade admsnap to version
2.9.x or later. Before you upgrade FLARE, verify that your operating
system version supports admsnap version 2.9.x or later. Refer to the
Admsnap ReleaseNotesorthe EMC Support Matrix on Powerlink.
Note: For the supported versions of these operating systems, see the Admsnap
Release Notes.

Installation prerequisites

Beforeyou can install and use the Admsnap Utility, you must:
Install SnapViewon a supported CLARiiON storage system. For
a list of supported storage systems, referto the release notes for
SnapViewand admsnap.
Enabledata access control on the same CLARiiON storage system.

Installing the Admsnap Utility on a Solaris server

EMC recommends that you install the most recent version of the
Admsnap Utilitysoftware that is appropriate for your configuration.
Youcan download the most recent version from either the software
download page on the Powerlink website (CX3–series and CX-series) or
onthesupportwebsite(AX-seriesstoragesystems).Youcanalsoinstall
thesoftware from the server support CD (any storage system); however,
the CD may not contain the most recent version for your configuration.
1. Log in to the Solaris server as a superuser,such as root.
2. Ifa previous revision is installed, remove it as described in Removing
the Admsnap Utility on a Solaris server, page 45.
3. Todownload the software for CX3–series or CX-series storage
systems, do the following:
42 EMC CLARiiON Server Support Products for Solaris Server Installation Guide