Parameter Description
Storage Processor B - IP
ADDRESS
IP address for SP B management port. For a
CX3–seriessystem, this IP address cannot be
128.221.1.250, 128.221.1.251,192.168.1.1, or
192.168.1.2b ecause these addresses are reserved.
Foran AX-ser ies storage system, this IP address
cannotbe 19 2.168.1.1 or 192.168.1.2 because these
addressesare reserved.
SubnetMas k Subnet mask associated with the LAN to which the
storage-systemman agement port is connected.
DefaultGateway Defaultgateway address for the LAN to which the
storage-systemman agement port is connected.
4. Enter the name you want for the storage system; it cannot exceed
32 characters.
5. When you have set the parameters to the values you want, apply
the values by typing a.
6. Using the information in the “Storage-System Management
Ports” worksheetfrom the storage-system configuration planning
guide, planning worksheets document, or the “Administration
Worksheet”,follow the instructions on the screen to change
the storage system’s name, if desired, and to set the following
management useraccount settingsfor the storage system:
7. When you have set the parameters to the values you want, apply
the values by typing a.
8. Exit the utility by typing e.
For a CX3-series storage system
If you entered an SP IP address for the first time or changed an SP IP
address,the utility reboots the storage system, and the SP fault light on
the back of each SP starts blinking. The reboot takes several minutes
to complete. When it is completed, the SP fault light (LEDs) on each
SP stops blinking and remainsoff.
For an AX-series storage system
If you entered an SP IP address for the first time or changed an SP IP
address, the utility reboots the storage system and the SP Boot/Fault
light on the back of each SPstarts blinking. The reboot takes several
minutes to complete. When it is completed, the SP Boot/Fault light on
each SP stops blinking and remains off.
14 EMC CLARiiON Server Support Products for Solaris Server Installation Guide