Installing and removing the Navisphere Storage System InitializationUtility
EMC recommends thaty ouinstall the utility on the server; however,
you can run the Navisphere Storage System Initialization Utility from
the server support CD.

Installation prerequisites

TousetheStorageSystemInitializationUtilityonaSolarisserver
to initialize a storage system, the server must meet the following
requirements:
Run a supported version of the operating system.
Beconnected to the same subnet as the 10/100 management ports of
the storage system that you want to initialize. This server may also
be aserver with Fibre Channel connections to the storage system.
If you have a previous revisioninstalled, you must uninstall it before
installing an updated version.

Installing the Navisphere Storage System Initialization Utility on a Solaris server

EMC recommends that you install the most recent version of the
Navisphere Storage System Initialization Utility software that is
appropriatefor your configuration. Youcan download the most recent
version from either the softwaredownload page on the Powerlink
website (CX3–series and CX-series) or on the support website
(AX-seriesstorage systems). Youcan also install the software from the
server support CD (any storage system); however, the CD may not
contain the mostrecent version for your configuration.
1. Log in as superuser (root)on a Solaris server that is on the same
subnet as the storage system.
2. If any previous revision of the initialization utility is installed on
the server,remove it before continuing.
Note: To verifyif the initialization utility is installed, enter the pkginfo
|grep HOST command.
EMC CLARiiON Server Support Products for Solaris Server Installation Guide 9