cdrom /cdrom0/solaris
4. Tostart the text-based utility or comma nd line utility from the CD,
enter ./naviinittooland for the command line utility, include any of
the command line switches in Using the command line initialization
utility, page 15.
Using the text-based initialization utility
Touse the text-based utility to i nitialize your storage systems, do the
following:
1. Read the license agreementand enter yto accept it
The utility automatically scans the subnet for supported storage
systems. When this storage-system discovery operation is complete,
the utility lists, by hardwareserial number, all uninitialized and
initialized storage systems it discovered. The hardware serial
number (HW S/N XXX 000NNNNNNNN) is on a label on the rear
of the chassis.
If the storage system you are installing was not discovered,verify
the cable connections between the storage system and the server
running the utility.
2. Enter the item number of the storage system you want to initialize
and press Enter.
3. Using the information in the “Storage-System Management
Ports” worksheetfrom the storage-system configuration planning
guide, planning worksheets document, or the “Administration
Worksheet”,follow the instructions on the screen to change the
storage system’s name, if desired,and to set the following network
parameters for the storage-system 10/100 management ports:
Parameter Description
Storage Processor A - IP
ADDRESS
IP address for SP A management port. Fora
CX3–seriessystem, this IP address cannot be
128.221.1.250, 128.221.1.251,192.168.1.1, or
192.168.1.2because these addresses are reserved.
Foran AX-ser ies storage system, this IP address
cannotbe 192.1 68.1.1 or 192.168.1.2 because these
addressesare reserved.
EMC CLARiiON Server Support Products for Solaris Server Installation Guide 13