EMC DS-16B manual Diag-Errstat, Diag-Init

Error Messages

Table C-3	Diagnostic Error Messages (continued)
Message		Description	Probable Cause	Action
DIAG-ERRSTAT		Port Error Statistics counter is non-zero,	ASIC, mainboard,	Replace
Err#2640-2647, 3040-3047, 3840-3847		meaning an error was detected when	GBIC module or	mainboard
[portLoopbackTest, crossPortTest,		receiving frames.	fiber cable failure	assembly, GBIC
		One of the following status errors		module or fiber
spinSilk]
		occurred.		cable
		Enc_in – Encoding error, inside frame
		CRC_err – Cyclic redundancy check on
		frame failed
		TruncFrm – Truncated frame
		FrmTooLong – Frame too long
		BadEOF – Bad end of file
		Enc_out – Encoding error, outside frame
		BadOrdSet – Bad symbol on fiber-optic
		cable
		DiscC3 – Discarded Class 3 frames
DIAG-INIT		Port failed to go active in the loopback	ASIC, mainboard,	Replace
Err#264F, 304F, 384F		mode requested.	GBIC module or	mainboard
[portLoopbackTest, crossPortTest,			fiber cable failure	assembly, GBIC
				module or fiber
spinSilk]
				cable
DIAG-INTNIL		ASIC failed to get a CMI error (interrupt)	ASIC failure	Replace
Err#2031				mainboard
[cmiTest]				assembly
DIAG-INTNOTCLR		The interrupt bit could not be cleared.	ASIC failure	Replace
Err#102C				mainboard
[centralMemoryTest]				assembly
DIAG-LCMEM		Data read from the Central Memory	ASIC failure	Replace
Err#1027		location did not match data previously		mainboard
[centralMemoryTest,		written into the same location		assembly
cmemRetentionTest]
DIAG-LCMEMTX		Central Memory transmit path failure:	mainboard failure	Replace
Err#1F27, 1028		ASIC 1 failed to read ASIC 2 via the		mainboard
[centralMemoryTest]		transmit path		assembly
DIAG-LCMRS		Central Memory Read Short: M bytes	ASIC failure	Replace
Err#1F25, 1025		requested but got less than M bytes		mainboard
[centralMemoryTest,				assembly
cmemRetentionTest]
Departmental Switch Model DS-16B Hardware Reference Manual