Emerson CC1000DM C.O. M. .P. O. .N. E. .N. T. S. . A. .N. D. . .F.E.A. T. .U.R. E. .S, Overview

OVERVIEW

. . . . . . . .

1

. . . . . . . . . . . . . . . . . . . . . . . . . . . ..

. . .

The Artesyn CC1000dm (dual mode) is a CompactPCI (cPCI) Processor Mezzanine Card (PMC) carrier capable of supporting Processor PMC (PrPMC) in both trans- parent and opaque (non-transparent) PCI to PCI bridge (PPB) modes of opera-

tion. The CC1000dm cPCI interface is compliant with both the PICMG® 2.0 CompactPCI® Specification and the PCI Local Bus Specification. The two PMC slots conform to the extended Processor PMC for Processor PCI Mezzanine Cards, VITA 32 -

2003 standard. Applications include:

•Wireless base station and gateway

•Voice over Packet (VoP) Signaling Gateway (SG), Media Gateway Controller (MGC), and SoftSwitch

•Access enterprise gateway

.C.O. M. .P. O. .N. E. .N. T. S. . A. .N. D. . .F.E.A. T. .U.R. E. .S. . . . . . . . . . . . . . . . . . . . . .

The following is a brief summary of the CC1000dm hardware components and features:

PCI-to-PCI Bridge: The CC1000dm uses a 64-bit, up to 66 MHz, dual mode transparent/non-transparent PCI bridge. The specific device is PLX Technology® PCI 6254 (HB6). The bridge chip also provides EEPROM support for extra register control. The cPCI interface in legacy mode is backwards compatible with the Artesyn CC1000 carrier card.

Blade Solution: The CC1000dm supports four modes. One of these provides an ideal blade solution, as it allows the CC1000dm to operate (via jumper selection) in a system without a cPCI sys- tem controller.

PMC Modules: The PCI Mezzanine Card (PMC) is a 64-bit interface that allows you to customize the CC1000dm by adding plug-on modules. The plug-on modules are based on the Periph- eral Component Interconnect (PCI) specification. The CC1000dm accepts two single- width or one double-width PMC module. The PMC slots are compatible with IEEE Stan- dard for a Common Mezzanine Card Family: CMC IEEE Std 1386-2001.

Reset Switch: The CC1000dm has a front panel push button that provides a reset function for the card.

Switching Regulator: The Linear Technology LTC®3713 provides the 3.3 volt conversion from the 5 volt input for the PMC slots.

10004281-02 CC1000dm User’s Manual 1-1