Emerson CC1000DM user manual Setup, Width Depth

SETUP	2
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
.
.
.
. .

This chapter describes the physical layout of the boards, the setup process, and how to check for proper operation once the boards have been installed. This chapter also includes troubleshooting, service, and warranty information.

Caution:

!

.E.L.E.C. .T.R.O. S. .T.A. T. I. C. . D. .I .S.C.H. .A.R. G. .E. . . . . . . . . . . . . . . . . . . . . . . .

Before you begin the setup process, please remember that electrostatic discharge (ESD) can easily damage the components on the CC1000dm hardware. Electronic devices, especially those with programmable parts, are susceptible to ESD, which can result in operational failure. Unless you ground yourself properly, static charges can accumulate in your body and cause ESD damage when you touch the board.

Use proper static protection and handle CC1000dm boards only when absolutely necessary. Always wear a wriststrap to ground your body before touching a board. Keep your body grounded while handling the board. Hold the board by its edges—do not touch any components or circuits. When the board is not in an enclosure, store it in a static-shielding bag.

Table 2-1:

Circuit Board Dimensions

To ground yourself, wear a grounding wriststrap. Simply placing the board on top of a static-shielding bag does not provide any protection—place it on a grounded dissipative mat. Do not place the board on metal or other conductive surfaces.

.C.C.1. 0. .0.0. D. .M. . .C.I.R.C. U. .I T. . B. .O. A. .R.D. . . . . . . . . . . . . . . . . . . . . . . . .

The CC1000dm circuit board is a cPCI carrier card assembly. It uses a 12-layer printed circuit board with the following dimensions:

Width:	Depth:
9.2 in. (233.35 mm)	6.3 in. (160.00 mm)

10004281-02 CC1000dm User’s Manual 2-1