Emerson CC1000DM user manual Identification Numbers Connectors, CC1000dm Circuit Board

2

Identification Numbers

Connectors

S E T U P

CC1000dm Circuit Board

Before you install the CC1000dm circuit board in a system, you should record the fol- lowing information:

❐The board serial number: 680– ______________________________________ . The board serial number appears on a bar code sticker located on the back of the board.

❐The board product identification: ___________________________________ . This sticker is located near the board serial number.

It is useful to have these numbers available when you contact the Technical Support department at Artesyn Communication Products.

The CC1000dm circuit board has various connectors (see the figures beginning on page 2 -3), summarized as follows:

P1–P2:These connectors are not installed on the CC1000dm.

J1: This 110-pin connector has keying for 3.3 volt and 5 volt supplies. See Table 4-3for the pin assignments.

J2: This 110-pin connector carries the PCI 64-bit extension signals. See Table 4-4for the pin assignments.

J3: This is a 95-pin connector that routes the I/O signals for the PMC I/O, serial port, and USB port. See Table 4-5for the pin assignments.

J5: This 110-pin connector is used for PMC I/O. See Table 4-6for the pin assignments.

J6: This is a 3-pin header for the Hot Swap switch.

J11: This connector shares the 32-bit PCI signals with the J12 connector (secondary bus). In addition, J11 supports a V(I/O) power supply for universal PCI signaling. It uses 3.3 volt PCI buffers with a 5 volt tolerance. See Table 3-9for the pin assignments.

J12: This connector shares the 32-bit PCI signals with the J11 connector (secondary bus). It also carries the 3.3 volt supply voltage. See Table 3-9for the pin assignments.

J13: This connector carries the 64-bit PCI extensions (secondary bus). See Table 3-9for the pin assignments.

J14: This connector is for user I/O, which routes to J3. See Table 3-9for the pin assignments.

J21: This connector shares the 32-bit PCI signals with the J22 connector (secondary bus). In addition, J21 supports a V(I/O) power supply for universal PCI signaling. It uses 3.3 volt PCI buffers with a 5 volt tolerance. See Table 3-10for the pin assignments.

J22: This connector shares the 32-bit PCI signals with the J21 connector (secondary bus). It also carries the 3.3 volt supply. See Table 3-10for the pin assignments.

2-4CC1000dm User’s Manual 10004281-02