Enterasys Networks ANG-1000 manual Ethernet Cables, Power, Connecting Cables

Chapter 2 Connecting Cables

Installation

All interconnections are made at the back of the ANG-1000 (refer to Figure 4). Although there is no power switch, a reset button is located in the rear of the unit.

CAUTION

If you press the reset button after you have configured your ANG-1000, you will lose your entire configuration. Any settings you supplied must then be re-entered. We strongly recommend that you do not use the reset button unless you want the configuration to return to factory defaults.

Ethernet Cables

The ANG-1000 is equipped with two 8-pin modular RJ-45 Ethernet ports labeled Trusted and External as shown in Figure 5. The Trusted port is connected to a computer or hub/switch with networked computers. The External port is connected to a cable or DSL modem.

Power
5Vd			T
c	2.5
		A	ru	st
				ed		Ext	er
				10	Ba
						se T	nal

Figure 5 Location of the Ethernet Ports

Reset

The trusted connection can be either a sole desktop computer or a hub that connects up to 25 tunnels to the network as shown in Figure 6.

Aurorean Network Gateway-1000 User’s Guide 5