Enterasys Networks ANG-1000 manual Do one of the following as shown in Figure, ANG-3000/7000

Connecting Cables	Chapter 2
	Installation

Connecting an ANG-1000

The ANG-1000 is typically set up in the configuration shown below.

INTERNET

Site-to-site tunnel

ANG-3000/7000

	External
Cable / DSL	connection
Modem

User

Trusted

connection

or

Hub

Aurorean Network

Gateway-1000

Site-to-site tunnel
Internet connection	User
Trusted connection	User

Figure 6 Connecting the ANG-1000

To connect the ANG-1000 Ethernet port, perform the following steps:

1Do one of the following as shown in Figure 7:

–If you are connecting to a hub, plug the blue, straight-through Ethernet cable into the Trusted port of the ANG-1000.

–If you are connecting directly to a computer, attach one end of the red, cross-over cable to the Trusted port and the other end to an RJ45 connector on your computer. Skip to Step 3.

2Plug the opposite end of the blue Ethernet cable into a wall jack, patch panel, or hub linked to a protected network segment.

The top link LED next to the ANG-1000’s Trusted port will immediately light if the port is connected to a 10 Mbps network after the unit is powered up.

6 Aurorean Network Gateway-1000 User’s Guide