Enterasys Networks ANG-1000 manual Front Power LED will light the moment you power up the unit

Connecting Power to the ANG-1000 Chapter 2

Installation

A switching power supply including a 6’ power cord and a 7’ electrical cord with an attached power supply is supplied with each system. To connect these items to an ANG-1000, perform the following steps:

1Plug the power supply cord into the system’s power socket as shown in Figure 8.

Power supply cable

Figure 8 Connecting AC Power on the ANG-1000

2Plug the correct end of the AC power cord into the power supply and the other end into a grounded AC outlet or UPS as shown in Figure 9.

The front Power LED will light the moment you power up the unit.

Power supply

AC power cord

Figure 9 Connecting the Power Cable to the Power Supply

NOTE

International customers may swap the electrical cord segment shipped with the ANG-1000 for a cord that meets the proper standard for their country. A custom cord can be inserted in the power supply.

8 Aurorean Network Gateway-1000 User’s Guide