3

Configuring the ANG-1000 with Aurorean Web Config

To configure the ANG-1000, use the Internet browser on your computer and connect to the server via the Web. During the Web session, you run the Aurorean Web Config utility and configure the system. Figure 13 illustrates the process.

Aurorean

 

Network

 

Gateway

 

 

Aurorean

Remotely Control ANG

Policy

Manager

 

PC Desktop

Figure 13 Configuring the ANG-1000 via Aurorean Web Config

Before You Begin

Before you begin configuration with Web Config, review the following:

HBe sure the ANG-1000 is cabled correctly as described in “Connecting an ANG-1000” in Chapter 2 of this manual.

HAsk your DSL or cable modem Internet provider and Network Administrator for any IP addresses, work group, network browsing or other information you may need to configure the ANG-1000 properly. Minimally, you will need:

The IP address of the ANG-3000/7000 you will connect to for setting up the VPN.

Aurorean Network Gateway-1000 User’s Guide

11

Page 23
Image 23
Enterasys Networks manual Configuring the ANG-1000 with Aurorean Web Config, Before You Begin