Chapter 2 | Connecting Power to the |
Installation
Optional crossover cable for direct PC connection
Trusted | External |
Figure 7 Connecting Ethernet Cables to an ANG-1000
3Plug an orange, straight-through Ethernet cable into the External port as shown in Figure 7.
4Plug the opposite end of this cable into a DSL or cable modem.
After you connect power, the top External LED at the rear of the
NOTE |
If you have a DSL modem, you will need to get an IP address from your provider and configure it before the External LED will light. This condition may also exist for selective cable customers. Some cable internet providers require that you supply the MAC address of your computer. Refer to Chapter 3 for directions.
Connecting Power to the ANG-1000
WARNING
To avoid electrical shock, connect the Aurorean system only to a grounded (earthed) outlet.
Aurorean Network | 7 |
