Enterasys Networks ANG-1000 manual Setting Up the Internet Connection

Chapter 3

Configuring the ANG-1000 with Aurorean Web Config

NOTE

If you press the reset button after you have configured your ANG-1000, you will lose your entire configuration. Any settings you supplied must then be re-entered. We strongly recommend that you do not use the reset button unless you want the configuration to return to factory defaults.

Setting Up the Internet Connection

Internet configuration of the External side of the ANG-1000 involves choosing the type of IP address assignment the ANG-1000 will accept. The ANG can accept one of the following:

HA DHCP-assigned IP address - your network automatically sets the ANG’s IP address via the DHCP (Dynamic Host Configuration Protocol) server.

HA Manual-assigned IP address - you or your network administrator set the ANG’s IP address and associated Subnet, Gateway, and DNS values. Consult with your Network Administrator for required values.

HA PPPoE (PPP over Ethernet) assigned IP address - your DSL provider transparently sets the IP address via the use of a Username and Password. Obtain this information from your service provider before you enter this data.

Begin Internet Setup by performing the following steps:

20 Aurorean Network Gateway-1000 User’s Guide