Epson 1000, 1500 or, or, (instepsof0.25), H E I G H T : X X P T, b SET 4.00 to 999.75 (instepsof0.25), PITCH 4 XXCPI b SET 0.44 to 99.99 (in steps of 0.01) or

Note:

To find out which font cards are available in HP emulation, see your dealer. For available font cartridges, see Chapter 5, “Options.”

After you select the font source, press A or v until the display shows the font number you want; then press ) to select the font. The font number is based on the font source option (RD, A,C,orDL)selectedabove.Theavailablefontsandtheir numbers are listed in the SelecType Level 1 FONT SAMPLE printout. If your are using the 3/P/Si emulation and the font you select is a scalable font, you must perform an additional step as follows.

If you select a proportional font, press A or v to select the font’s point size. Then press b once to set that point size.

Menu/submenu	Available options
H E I G H T : X X P T .	b SET 4.00 to 999.75 (instepsof0.25)
	or ******

If ******appearsonthedisplay,thepointsizeyouselectedis outofthepossiblerangeof4.00to999.75.

If you selected a fixed pitch font, press A or v to select the spacing in characters per inch. Then press b once to set that spacing.

Menu/submenu Available options

PITCH 4 XXCPI b SET 0.44 to 99.99 (in steps of 0.01) or *****

If***** appears on the display, the spacing you selected is out ofthepossiblerangeof0.44to99.99.

If you change the SYMSET setting, the available font numbers may change. To save the selected font as the default font, use theSAVEMACROoptionintheLevel1 SYSTEMCONFIG. menu.

HP Emulation Mode B - 7