The following commands are available in FX emulation but not in LQ emulation:

ESC1

7/72-inch line feed

ESC^

Select

9-pin graphics mode

ESCI

Select

character code table

The following commands are available in LQ emulation but not in FX emulation:

ESC+

Select n/360-inch line spacing

The printer commands listed below function in a slightly different way when used in the LQ or FX emulations. Also, many of the commands that control the print position use approximations because of the difference in print density between the LQ and FX printers.

ESCG/ESCE

These commands produce identical bolding effects on your printer. On an actual LQ series printer, these two commands create slightly different effects and can be combined to produce darker characters.

SI/ESC SI

Thesecommandsprint10cpicharacters ina16.66cpifont,and 12cpi charactersina20cpifont.OnanactualLQ/FXseries printer, these commands condense the font.

ESC x

This command is normally used to select between draft and LQ quality with an LQ or FX printer. However, this command has no effect on your printer’s print quality since all characters are printed at 300 dpi (dots per inch).

LQ and FX Emulation Modes C-15