If you need to change any jumper settings, follow these steps:

1.Remove any option cards that may be blocking your access to the jumpers. See page 5-15 for instructions.

2.Change the jumper settings as necessary.

3.Replace any option cards you removed. See “Installing an Option Card,” below.

4.Follow the instructions on page 5-30 to replace the computer’s cover.

Installing an Option Card

Your computer has four standard option slots: three 16-bit slots and one B-bit access slot. Each slot can accommodate an option card. You can buy option cards from authorized Epson dealers as well as other vendors.

This section explains how to install option cards in your computer. Later on, you may need to remove an option card to access jumpers, memory modules, or a math coprocessor. If so, see “Removing an Option Card” on page 5-15 for instructions.

Note

After you install or remove an option card, see “Post- installation Setup” at the end of this chapter to configure your computer to operate with or without the option card.

5-10 Installing and Removing Options