Follow these steps to change your built-in serial and parallel interface settings:

1.At the main menu, highlight Serial/Parallel.The current settings for each port appear:

Serial PrimaryParallel Primary

2.Press Enter to move the cursor block into the submenu. You see this additional option menu:

DisabledPrimarySecondary

3.If you want to change the serial port setting, be sure Serial is highlighted and press Enter. If you want to change the parallel port setting, highlight p a r a 1 1 e 1 and press Enter. The cursor block moves into the submenu.

4.Use or to highlight the appropriate setting for the port you selected and press Enter. The screen displays the new setting.

Note

If you add an option card with a parallel or serial port and highlight a setting that causes a conflict between your built-in port and the port on the option card, you see- this message:

Conflict with option card

Highlight a setting that is appropriate for your system configuration and press Enter.

2-28 Running the Setup Program