5.As you lower the drive into the vertical mounting area, guide the long end of the cable underneath the drive and curl up the short end behind the drive.

tabs

As shown above, fit the tabs on the mounting plate into the slots on the side of the subassembly. Then tilt the drive toward the subassembly and align the retaining screw hole on the mounting plate with the hole in the bracket.

6.Secure the drive to the bracket with the retaining screw.

If you used the instructions above to install your drive while the subassembly is out of the computer, see “Replacing the Subassembly” on page B-47. Do not follow the steps in the next section.

Installing and Removing Disk Drives

B-17