6.Line up the pins on the coprocessor with the inner two rows of holes in the socket. You should feel the pins drop into the holes when they are aligned properly.

7.Gently push the coprocessor into the socket, pressing evenly on all sides of the coprocessor, as shown below.

If the coprocessor does not go in smoothly, do not force it; pull it all the way out and try again, keeping it straight as you insert it.

Examine the coprocessor to be sure it is inserted all the way into the socket.

8.Follow the steps on page 5-30 to replace the computer’s cover. Then see “Post-installation Setup,” following that section, for instructions on configuring your computer for use with your math coprocessor.

Installing and Removing Options

5-29