Check each Setup summary screen to see if all the information is correct. You can press PgUp to display the previous screen or PgDn to display the next screen. If anything is incorrect, be sure Change settings is highlighted and press Enter. The main Setup menu appears and you can change the appropriate settings.

Leaving the Setup Menu

If you did not change any settings or you want to cancel the changes you made, highlight Exit without saving at a Setup summary screen and press Enter. The Operation Menu appears. (If you changed the time or date, the new setting takes effect even if you exit the Setup program without saving your changes.)

If you want to save the settings you entered, highlight ** EXIT AND SAVE * * and press Enter at a Setup summary screen. The Setup program stores the new settings and resets the computer using the new configuration. If you have set a password, you need to enter it at the key prompt. (See “Using a Power-on Password” in Chapter 3 for instructions.) The Operation Menu appears.

If you have just run Setup for the first time, remove the Reference diskette from the drive and turn off your system. Then follow the instructions in your MS-DOS Installation Guide to install MS-DOS. (If you are using a different operating system, follow the installation instructions in that manual.)

Once you have installed MS-DOS, you should always boot the computer from the hard disk or the MS-DOS Startup diskette when you are finished running Setup. First remove the Reference diskette from drive A. If you do not have a hard disk, insert the Startup diskette. Then reset your computer to make sure it performs all the commands in the CONFIG.SYS and AUTOEXEC.BAT files.

Running the Setup Program.

2-31