Reconnecting the Cables to the Diskette Drive
Refer to the illustration below while you follow these steps:
red wire | red wire |
1.Locate the connector on the diskette drive ribbon cable.
2.Identify pin 1 on the drive and align the connector so that the red wire is at pin 1. Push in the connector.
3.Locate the power supply cable with the small connector.
4.Position the power supply cable connector so that the holes fit over all the pins and the red wire aligns with pin 1 on the drive’s connector. Then push in the connector.
5.If you have finished installing or removing drives, replace the computer’s cover, as described under “Replacing the Cover” in Chapter 4. Then see “Using the Fixed Disk Setup Option” in Chapter 2 for instructions on defining your new drive configuration.