After you have changed JP49, restart your system, leave it on for a few seconds, then turn it off again. This resets the SETUP values to their factory defaults. Both the Supervisor and the User passwords are disabled.
Remove the jumper from JP49. Then turn the computer on again. If you want to set a new password, use SETUP as described under “Selecting the Security Setup Options” in Chapter 2.
Software Problems
Your operating system won‘t start after you installed the PCI IDE drivers.
If you installed PCI IDE drivers for another operating system, such as UNIX, make sure you followed the instructions in the README file for the drivers. See “Installing the PCI IDE Drivers” in Chapter 2 for instructions.
The application program does not start
Check that you are following the correct procedure for starting the program and that it is installed correctly. If you need help, contact your software manufacturer.
The application program cannot read a key disk.
You may be running an application that requires a slower processor speed. From the
Troubleshooting