3.Remove the screws securing the drive on both sides.
4.Reach behind the drive and gently push it out through the
front of the bay; then pull it out of the slot.
5.Once you have removed the drive, replace the faceplate by inserting one side of the plate, then gently pressing on the other side until it snaps into place.
6.If you removed the only IDE device connected to the interface the device used, you may want to disconnect the device cable from the main system board and remove it from the computer.
7.Replace the drive mounting bracket. See “Replacing the Bracket in the Computer” for instructions.
8.If you have finished installing or removing drives, replace the computer’s cover, as described under “Replacing the Cover” in Chapter 4. Then see “Using the Fixed Disk Setup 0ption”in Chapter 2 for instructions on defining your new drive configuration.
Installing and Removing Slimline Drives |