Note

If you use ECP mode (Extended Capabilities Port), check your parallel device software documentation for the correct DMA channel (DRQ) setting. Then set jumpers JP8 and JP18 to match this setting if necessary. See “Changing the Jumper Settings” in Chapter 4 for more information.

Using the serial port

If you have a printer, a modem, or other device with a serial interface, you can connect it to one of the serial (RS-232C) ports. Make sure you have a cable compatible with a DB-9P connector.

To connect a serial device, insert the connector into either of the two serial ports, which are marked with the icons shown at the left. If you are connecting only one serial device, use the serial 1 port.

Connecting the Power Cord

Follow these steps to connect the computer’s power cord:

1.Plug the power cord into the power inlet on the back of the computer. Note that the position of the power inlet and AC outlet on your computer may be reversed.

Setting Up Your System

1-7