The printer loads more than one sheet at a time.Cause What to do
Too many sheets are loaded
in the sheet feeder. Take the paper stack out of the feeder,
remove some sheets, and reload paper.
Before you load paper, see page 6-4 to
check the amount of paper you can
load in the sheet feeder.
The edge guides are not set
correctly. Adjust the guides agai nst the stack of
paper. See “Loading Paper” on page
3-2.
The paper was not fanned
before being loaded in the
sheet feeder.
Remove the paper stack and fan it.
Tap it on a flat surface to even the
edges. Then reload the paper.
The edges of the paper stack
are not even. Remove the paper stack and tap it o n a
flat surface to even the edges. Then
reload the paper.
The paper is too thin. Make sure the paper meets the paper
requirements for this printer. See
“Paper” on page B-2.
Ejected paper is wrinkled. Cause What to do
The paper is damp. Do not store your paper in a damp or
humid environment. Store paper in its
original packaging.
The paper is too thin. Make sure the paper meets the paper
requirements for this printer. See
“Paper” on page B-2.
8
Troubleshooting
R
Comoro-W
Rev.C
A5 size Chapter 8
12-12-97 DR, pass 0
Troubleshooting 8-15