Epson Photo750 manual Absorber Tray, AssemblyA Removal

EPSON Stylus Photo 750 Revision A

4.2.4 Absorber Tray, Assembly;A Removal

1.Remove the upper housing.(See “Housing Removal” on page -54)

2.Remove the control panel. (See “Control Panel Removal” on page -57)

3.Remove one screw securing the “Absorber Tray, Assembly;A” to the right side of the printer mechanism.

4.Remove “Spacer Tray” securing “Absorber Tray, Assembly” at the left side of the printer mechanism and remove “Absorber Tray, Assembly;A” by pulling it downward.

CA U TBeIsureO Nto reset the waste ink counter, when replacing the “Absorber Tray, Assembly;A” or absorber(ink pad) inside. (See “Special Setting Mode” on page -22)

S e c t io n ( A )

W a s t e I n k P a

S p a c e r , T r a y

[ P r o je c t io n s ]

C H E P O I

After installing the “Absorber Tray, Assembly;A”, be

sure that 2 points of “Stopper Stacker” installed on the exit roller shaft are pushed back to the back of the rear side of protrusion of “Absorber Tray, Assembly;A”.

" R o lle r , A s s e m b ly , E x it " S h a f t F r o n t s id e

P u s h " S t o p p e r , S t o p p e r , S t a c k e r t o t h e b a c k o f

Figure 4-6. Absorber Tray, Assembly;A Removal

Disassembly and Assembly Disassembly 58