Epson Photo750 manual Paper Gap Adjustment, „ Do not scratch special coated surface of the PF

EPSON Stylus Photo 750 Revision B

5.2 Adjustment

This section describes the detailed procedures of each adjustment.

5.2.1 Paper Gap Adjustment

When replacing the carriage assembly or removing it during printer mechanism disassembly, perform the paper gap adjustment during assembling and get the standard distance from the surface of the printing head to the paper surface.

„ Do not scratch special coated surface of the PF

C A U T I O N

roller and rib surface of “Paper Guide, Front ;B”.

„Be careful not to leave any dirt or scars on the surface of the print head.

L e f t	" P A P E R G U I D E , F R O N T ; B "
		R ig h t
		( H P s id e )

R ib : A v o id 2 r ib s f r o m le f t		R
C a r r ia g[ Te h ic k n e s s G a u g e ]
A s s e m b ly
	* P u t t h e g a u g e o n a
	* A lig n t h e c e n t e r	o
	t h e r ib s

" R O L L E R , A S S E M B L Y , P F "

" P A P E R G U I D E , F R O N T ; B "

†Paper Gap Adjustment

1.Install the “Bush, Parallel, Adjustment” for right and left frame and set them on the peaking of the upper frame side so that they match with the standard mark of “Bush, Parallel, Adjustment”.

2.Set the “Lever, PG” front. (Gap: “0”)

3.Move the carriage to the center and set the thickness gauge(1.14mm thick) on the fixed position of “Paper Guide, Front;B” as you can see in the figure5-1.

CA U TDoInotO Nuse the same thickness gauge you used for

Stylus Photo and Stylus Photo 700.

Figure 5-1. Paper Gap Adjustment

4.Move the carriage to the position that the print head overlaps the thickness gauge.

CH E „ Leave the thickness gauge on the flat side of the rib

P O I of the front paper guide;B.

„When you move the carriage, move it , pulling the timing belt with your hand.

5.Move the “Bush, Parallel, Adjustment, Right” to the rear until the thickness gauge moves with the carriage when you move the carriage about 20mm right and left. (Gap will be narrowed)

Adjustment Adjustment 78