EPSON Stylus Photo 750

Revision A

6.1 Overview

This section describes the points and procedures for maintaining the printer in its optimum condition.

6.1.1 Cleaning

This printer has no mechanical components which require regular cleaning. Therefore, note that points suggested below are only to check for dirt, and perform appropriate cleaning if necessary.

Never use chemical solvents, such as thinner, to

C A U T I O N

clean the printer. These chemicals can damage the components of the printer.

Be careful not to damage the components when you attempt to clean the inside the printer.

Do not scratch surface(coated part) of “Roller, Assembly, PF”. Use soft brush to wipe off any dusts. Use a soft cloth moistened with alcohol to remove the ink stain.

Exterior parts

Use a clean soft cloth moistened with water and wipe off any dirt. If the exterior parts are stained with ink, use a cloth moistened with neutral detergent to wipe it off.

Inside the printer

Use a vacuum cleaner to remove any paper dust.

6.1.2 Service Maintenance

If the print irregularity missing, white line, etc.) has occurred or the printer indicates “Maintenance Request Error”, take the following actions to clear the error.

Head Cleaning

The printer has a built-in head cleaning function and is activated through the control panel operation.

1.Confirm that the printer is in stand-by state(the Power indicator is not blinking), and press “Cleaning” button.

2.The printer enters the built-in cleaning sequence, and head cleaning is performed.

Maintenance Request Error

Ink is used for the operation such as cleaning as well as printing. Therefore, the printer wastes certain amount of ink and counts the amount of the wasted ink and drains it into the waste ink pad(absorber). Once the amount of wasted ink reaches the predefined limit, the printer indicates “Maintenance Request Error”. Then, the waste ink pad should be replaced and ink consumption counter recorded in EEPROM should be initialized.

1.Replace “Absorber Tray, Assembly;A”.

2.Turn the printer ON, holding down “Load/Eject” and “Cleaning” buttons.

3.Press “Load/Eject” button, while the “Paper Out” LED is blinking.

Maintenance

Overview

91

Page 96
Image 96
Epson Photo750 manual Cleaning, Service Maintenance, „ Never use chemical solvents, such as thinner, to