Epson Photo750 manual Roller Assembly, LD Left/Right Removal, Roller Assembly, LD Removal

EPSON Stylus Photo 750 Revision A

4.2.5.7 Roller Assembly, LD Left/Right Removal

1.Remove “ASF, Assembly”. (See “ASF, Assembly Removal” on page -65)

2.Remove right and left “Compression Spring, 1.66” from the back of “Hopper, Assembly”.

3.Pull out the cam part of “Hopper, Assembly” through the hole of the right frame of “Paper Feed, Roller Assembly, Right”. This will separate “Paper Feed, Roller Assembly” and “Hopper, Assembly”.

4.Unlock “Roller Assembly, LD” from the assembly frame and remove “Cover, Roller, LD” by unhooking it from the assembly frame. Then, remove “Roller Assembly, LD”.

CH E „ When installing “Roller Assembly, LD”, make sure

P O I that it is hooked to the assembly frame firmly.

„Before re-assemble the unit, make sure that “Compression Spring, 1.66” is set on the assembly frame and hooked to the hooks as it is shown in the figure. This helps you easier assembly. After assembling the unit, do not forget to unhook the springs by rotating the spring from the holes located at the back of the ASF assembly.

C O V E R , R O L L E R , L D ( L / R )
+	C O M P R E S S I O N S P
H O L D E R , S H E E T , P F

R O L L E R , A S S E M B L Y , L D ( L / R )

A S S E M B L Y F R A M E

S e t t h e s p r i			g a n d h o o k it
	n
t o t h e a s s e m		b	ly f r a m e		a s
illu s t r a t e d , b			e f o r e r e	- a s s e		m	b ly

Figure 4-18. “Roller Assembly, LD” Removal

Disassembly and Assembly Disassembly 67